Statement wallpapers deserve a flawless finish — and when it comes to our snaked (continuous) designs, correct installation is key to achieving that seamless, flowing look across your wall.
Unlike standard repeat patterns, snaked designs are created to move across panels in a specific order, forming one continuous scene. This means careful planning and precision are essential.
Follow our step-by-step guide below to get it just right.
What Is a ‘Snaked’ Design?
A snaked design is a mural-style wallpaper where each panel connects in sequence, rather than repeating the same pattern. Each drop is unique and must be hung in the correct order to maintain the design flow.
Before You Start
Before hanging your wallpaper, make sure you:
- Check your roll layout and panel order
- Measure your wall height and width accurately
- Ensure your wall is clean, dry, and smooth
- Have all tools ready (paste, brush, plumb line, knife, etc.)
Tip: Always lay out your panels on the floor first to visualise the full design.
Understanding Your Measurements
Each snaked design is created to fit a specific height and width. For example:
- Panel height: Typically around 250cm
-
Roll width: Varies (e.g. 150cm per panel)
Your design will be split into evenly sized vertical panels that must be installed side by side in order.
Step 1: Start from the Left
Always begin hanging from the left-hand side of your wall unless stated otherwise.
- Use a plumb line or level to ensure your first panel is perfectly straight
- This first drop sets the alignment for the entire design
Step 2: Follow the Panel Order
Each panel will be numbered or arranged in sequence.
- Hang panels left to right
- Match edges carefully — the design should flow naturally between panels
- Avoid trimming edges before confirming alignment
Do not treat this like a repeating wallpaper — panels are not interchangeable.
Step 3: Align the Design (Not Just the Edges)
With snaked designs, visual alignment is more important than edge perfection.
- Focus on matching key elements (e.g. trees, snakes, florals)
- Gently adjust positioning before smoothing down
- Step back regularly to check the overall look
Step 4: Smooth and Secure
Once aligned:
- Smooth from the centre outward to remove air bubbles
- Use a clean brush or smoothing tool
- Wipe away excess paste immediately
Step 5: Trim Carefully
After each panel is secured:
- Trim excess at the top and bottom
- Use a sharp blade for clean edges
- Take care not to pull or distort the design
Common Mistakes to Avoid
- Hanging panels out of order
- Starting without a straight guide line
- Treating panels as repeat patterns
- Rushing alignment
Final Tips for a Seamless Finish
- Work slowly and methodically
- Have a second person help with positioning
- Always check alignment before committing
- Keep your tools clean to avoid marks
With the right preparation and care, your snaked wallpaper will create a stunning, continuous feature wall that truly transforms your space.
